for SNES/SFC Classic
$16.99
Colors:
Mod Kit (Receiver not included) Retro Receiver for SNES Classic (Mod Kit not included)
Firmware Updater:
Downloads
FAQ
Can the Classic Kit and Original Kit be used interchangeably? What are the differences? How can I differentiate them from each other?
No, they can not be used interchangeably. The differences include the thickness of the board and the placement of the buttons. When choosing the right kit to buy, please refer to the controller port of your controller: A. The long and flat one is the original model B. The short and narrow one is the Classic model
What devices are they compatible with?
They are compatible with Switch, Windows 10, Android, macOS, Raspberry Pi. They will auto reconnect to any device with the press of START once it has they paired successfully.
How can I upgrade the firmware?
A. Download the Firmware Updater from https://support.8bitdo.com/firmware-updater.html first B. Connect the board to your computer via a USB cable C. Choose the right file for your kit to run Note: a. the cable included in the packaging and the circular port attached to the port are for power charging only. b. be extra careful with power port during the procedure to avoid damaging it.
How can I charge the controller when modded?
The cable included in the packaging and the circular port attached to the port are for charging the battery.
What should I do if my controller does not charge and there is no LED indication of its charging?
A. Open up the controller enclosure with the screwdriver provided in the packaging B. Connect the board to your PC via a USB cable C. LED turns on If there is no LED, it means the power port is damaged
Why does my SNES original get disconnected all of a sudden?
This can be caused by the dust collected around the buttons. Try to clean the START and SELECT buttons thoroughly, this should fix the issue.
Can I map the buttons? What can I do if I incorrectly mapped the buttons?
Yes, you can map the buttons. This is what you can do if the buttons are incorrectly mapped: LEFT + Select : set Dpad as left analogue stick Up + Select : reset Dpad Right + Select : set Dpad as right analogue stick Down + Select : Swap A/B and X/Y mapping *Press and hold any of the key combinations above for 5 seconds to map the buttons. *LED will blink in red to indicate the success of each button mapping. *You need to reset the buttons manually.
How can I charge my controller after modifying it? How long can the battery last when fully charged?
We suggest you use a phone power adapter to charge the battery. It uses a 180mAh rechargeable battery. It takes about one and half an hour to fully and can last for about 10 hours.
Can I use it as a wired controller?
No, you can not. The cable which comes with the board is a USB DC2.0 powering charging cable only.
